The case is a snug fit, with only 0.2mm offset from the DASBOB PCB by GroooveBob.

• Layer height: 0.2mm or less
• Filament: PLA or PETG

Required parts

• M2 * 4mm GB823 screws
• M2 * 2mm (height) * 3.5mm (OD) brass heat set threaded inserts

This model was heavily inspired by @beekeeb's minimal dasbob case, but with the following adjustments:

• Slightly thicker base (2mm) for rigidity
• Bottom Insets for 8mm diameter bumpons--to keep them in place, and to reduce placement decisions
• Wider screw (M2 * 4mm) mounts

Attribution:

• Original Model from beekeeb
• Remixed by twalker2k
• I (@RufusRed) just loaded the file from Printables into Bambu Studio and setup a profile for the Bambu X1C, no model modifications.