Simple Build Plate Storage
Copyright Claim
Simple Build Plate Storage
Boost
17
50
4
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
53 min
1 plate
Open in Bambu Studio
Boost
17
50
4
0
45
39
Released
Description
quick and easy to print holder for storing up to 3 build plates directly on the printer. the holder can be attached directly to the side of the printer without additional fastening.
Comment & Rating (4)
All
Print Profile
0.2mm layer, 6 walls, 25% infill
Perfect
(Edited)
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Very simple design!
It does slide side to side when attempting to add/remove a plate but nothing some double sided tape can’t work around.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Simple print, no issues, well done.
For reasons unknown i cant make 5 start , i did print this, it says i didnt :(
I used a little double sided tape on it also , i dont think it was 'needed' , but just in case :)
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld