This painting has 0 dose of reality but I like it :) Say “hello” to the Evil Broccoli!

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

• PLA BambuLab Basic Black
• PLA PolyTerra Charcoal Black
• PLA BambuLab Basic Green
• PLA BambuLab Basic Blue Gray
• PLA BambuLab Basic Gray
• PLA Overture Light Gray
• PLA BambuLab Basic Jade White

Swap Instructions:

• Start with Black
• At layer #7 (0.64mm) swap to Charcoal Black
• At layer #8 (0.72mm) swap to Green
• At layer #12 (1.04mm) swap to Blue Gray
• At layer #14 (1.2mm) swap to Gray
• At layer #20 (1.68mm) swap to Light Gray
• At layer #25 (2.08mm) swap to Jade White for the rest.

Enjoy my work? Support me by joining my club on printables. Tier 1 offers exclusive models, while Tier 2 allows you to sell my 3D printed artwork.