I made this fidget toy because I was bored and it turned out to be quite satisfying. I haven't seen a magnetic slider toy in the shape of a triangle so it is quite unique in that way.

You can edit the stl and remix the model to add your own design on top or resise the magnet holes if you need to.

Instructions:

Required Materials:

6 Magnets of about 0,5 x 1,0 centimeters

Recommended Settings:

10% - 20% infill

No supports

You need to pause your print halfway

To insert the magnets propperly you have to pause the print right before it closes up the magnet holes.

This can be done by editing the g-code in the slicer, I recommend looking up a tutorial on how to do this for your slicer.

The magnets dont have to be exactly 0,5 x 1,0 cm. You can use smaller magnets too, but if you do so make sure to superglue them in before resuming the print.

Other than that it is an super easy print, because of the large contact area with the build plate. It also doesnt take long.