This is a 3 shot inline clip for the Dart Zone Solo. It replaces the stock front end (orange pieces and barrel). Simply insert the trigger between the holes and reassemble the blaster as normal.
Performance went from a consistent ~108 fps with DZMax darts to 90-95 (with v1.1 I am seeing 95-105) with all shots in the inline clip. Worker darts showed a greater fps variation both stock and with the inline clip, so I'm recommending DZMax darts for this due to the consistency.
11/25/23 - Added "Tactical" version with built in iron sights and some picatinny rail under the barrel.
11/28/23 - Added a version with a tighter muzzle to account for printer tolerance and dimensional accuracy issues. Use whichever version works better with your printer.
12/2/23 - V1.1 - Air seal Improvements in the back & adjusted the "Tight" versions to be not so tight.
12/5/23 - Added "SuperTactical" version that has an extended bottom picatinny rail and picatinny rails on each side as well. Still prints with no supports. Is it silly? Yes. Have fun.
Print should be oriented correctly in the file (muzzle down so the whole thing prints at an angle). No supports required.
For an extended release lever:
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.