Desk stand for XTouch using ESP32-2432s028 by Avlastuin

Avlastuin

3D Printer>3D Printer Accessories

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

57 min

1 plate

4.8(86)

0.16mm layer, 2 walls, 15% infill

1 h

1 plate

4.9(25)

Open in Bambu Studio

Boost

128

209

128

698

535

Released

Description

A desk stand for XTouch using a ESP32-2432s028.

assembly: use 4x12mm M3 screws to secure the front to the back.

Power: use the micro usb port or solder a usb cable to the back of the board and use the hole in to back for the cable

Comment & Rating (128)

@DDAAANNNIEELLL

Print Profile

0.2mm layer, 2 walls, 15% infill

this is so good! looking very nice and the display is fitting perfect. i like the frame that has almost no gap to the screen. Also nice is the fact that you can use it in two different ways.

@dominikest

which Filament? <3 ?

@DDAAANNNIEELLL

Replying to @dominikest :

Bambu Lab Matte Pla✌️

@SimonMoon

Very nice case and easy to print. The only thing I miss, would be the ability to use the buttons on the back.

@mindblowing3D

Print Profile

0.2mm layer, 2 walls, 15% infill

The display fits perfectly into the housing. There is also enough space to insert or remove the SD card. I only glued it on the top and bottom because I didn't have any screws. It is a great case which I can use to put it on the desk or on the printer.