This is 4 color HueForge of Forest with wolf and bear.

I used glow in the dark fillament to get the nice effect, but you can use any other fillament collor you would like.

I uploaded two sizes 200x200 X1/P1/A1 and size 180x180 for A1 Mini.

Do not adjust the thickness (Z) in your slicer!! The layers will not come out right. You can adjust the other dimensions (X,Y) though to make it bigger or smaller, just not the thickness.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 200x200mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.3mm and the Actual Depth is 2.2mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Glow Glow Yellow Transmission Distance: 8
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
Start with Black
At layer #9 (0.8mm) swap to Blue Gray
At layer #13 (1.12mm) swap to Glow Yellow
At layer #19 (1.6mm) swap to Jade White for the rest.