Creature from the Black Lagoon movie poster magnet
Boost
13
15
7
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
3.2 h
1 plate
Boost
13
15
7
1
9
12
Released
Description
Creature for the Black Lagoon movie poster fridge magnet.
Measuring 65mm wide by 95mm high by 5mm deep
4 colour AMS print, using black, white, ash grey and blue.
This needs 4x 8mm diameter by 2mm deep magnets, the magnets push into the model after printing, no need to pause.
NOTE - The magnets are designed to be a tight fit. The best way to insert them is to line up a magnet with a hole then place the model on a hard flat surface facing up, with the magnet on the hard surface, then press down firmly on the model. The magnet will snap into place. Repeat for each magnet.
Comment & Rating (7)
All
Print Profile
0.08mm layer, 2 walls, 15% infill
Came out much better than it looks in my photo. :)
0
Reply
Thanks for getting back to the 4-color prints! I might pull the trigger on a 2nd AMS, at some point, but I just don't have the space for it. So, color (or, multi with pauses) are all I can deal with. LOVE the UMonster series...will be printing them all! :)
The designer has replied
1
Reply
Hi, I'm glad you're liking the new models! I do try and keep a mix of 1 and 2 AMS models :-)
1
Reply
Replying to @crabstiks
Correction: So, 4-color (or, multi with pauses)
0
Reply
Replying to @rggalvin
The 4+. Colour ones with pauses are really difficult to pull off and time consuming too so not many of those ones get done
1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld