Modular Spice Rack by Rawsen Mitchell

Rawsen Mitchell

Household>Other House Models

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

6.5 h

4 plates

5.0(8)

Boost

161

368

123

Released

Description

A simple, modular spice rack with sliding trays for easy access. The model is 10" deep, but I've included the SW model in case you need to change the dimensions.

Comment & Rating (15)

@deviltrini

Print Profile

0.2mm layer, 2 walls, 15% infill

had to remake some since I broke it but it works great.

The designer has replied

@mitchellR_

good to hear! I tried adjusting the tolerances on the posts, but just printing them at a higher wall count will have the most impact

(Edited)

@user_3929128318

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Print and design are very good. The legs were a tight fit and I needed a mallet but the print feels very sturdy. It can hold containers 2 inches wide and just under 5 inches tall on the lower shelf

@juanhardin82

Print Profile

0.2mm layer, 2 walls, 15% infill

The designer has replied

@mitchellR_

I realize now that it might not have been totally obvious, but the rounded corners on the posts match the rounded corners on the tray. Otherwise, love how the print turned out!

@user_2724046821

Boosted

Just what I needed, thank you~!

The designer has replied

@mitchellR_

Good to hear!

@DuellM

This is awesome I just wish it had stops to prevent the try from coming all the way out if I forget not to pull to far

The designer has replied

@mitchellR_

I debated adding that in when designing it, but I wanted to use the trays as a method of carrying a bunch of spices at once. I'll note it for the next iteration!

@user_1225601512

Print Profile

0.2mm layer, 2 walls, 15% infill

Nothing much to say. It came out as expected. You have to be careful about inserting the standoffs as I broke one and it was a bear to remove it. Increasing the infill might help or just realize that once inserted, its in.

The designer has replied

@mitchellR_

A bit of pre sanding goes a long way. Printers like to blob a bit when making tight corners, so that’s a big reason why it’s tighter than it should be I’ll go in and change it, thank you for your descriptive feedback!