Pwnagotchi Case (without PiSugar now AMS)
Remixed by
Copyright Claim
Pwnagotchi Case (without PiSugar now AMS)
Remixed by
Boost
0
0
0
Print Profile(6)
0.15mm layer, 2 walls, 15% infill Change Text and Icon
Designer
6 h
1 plate
0.15mm layer, 2 walls, 15% infill SD card highlight
Designer
4.2 h
1 plate
0.15mm layer, 2 walls, 15% infill No Design
Designer
1.4 h
1 plate
0.15mm layer, 2 walls, 15% infill (all) no design
Designer
1.4 h
1 plate
Click to see more
Open in Bambu Studio
Boost
0
0
0
0
2
1
Released
Description
Short Notice
I recommend adding some glue on the sides of bottom snap covers to keep the lid attached better to the main case. In this case I tried to align the SD card accurate as possible.
Components for Pwnagotchi I used:
- Raspberry Pi Zero W.
- Waveshare E-Paper 2.13 inch v4 display.
- Battery 1200mAh, 3.7v.
- TP4056 charging board.
Needed Items:
- Glue.
- Foam (For filing inside space and pressing the display closer to case securing it with battery) Optional
- BMS/Charging module (TP4056 recommended)
- Battery 1000mAh or 1200mAh Lithium Ion 3.7v
- Switch.
Setup:
Manually switch goes on top, BMS goes to side where C-Type hole is, glue it ON BOARD, NOT CASE as close to hole for whole raspberry pi zero and display removable. Connect battery and move battery in the back where back cover is and add foam at the brackets to secure the board or press to case, and battery, so it won't move along the case.
Comment & Rating (0)
All
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld