I was building a station for my Bambu printers to live. At the suggestion of theh Bambu community, I went with the Ikea Bror shelving unit and the Skadis pegboard. Ikea doesn't offer a great way to mount the skadis to the bror shelving unit. When looking at how most people in the community had mounted theirs, I saw they were placing the shelving unit up against a wall and then mounting the skadis to the wall behind the unit. This didn't fit my needs. So I threw together a quick model that mounts the skadis to the bror shelving unit.
The Shelving unit is the Bror and can be found here: https://www.ikea.com/us/en/p/bror-shelving-unit-black-s49471980/#content
I added the drawer: https://www.ikea.com/us/en/p/bror-drawer-black-00494662/
and the additional shelf with a wood top: https://www.ikea.com/us/en/p/bror-shelf-black-pine-plywood-20343163/
The skadis pegboard can be found here: https://www.ikea.com/us/en/p/skadis-pegboard-black-50534378/
you will need:
See the pictures included for placement and direction of the screws.
For the side with 1 hole, the screw will go from the back side of the bror unit through the bracket → bror support upright → washer → nut.
The side with the two holes the screws go through the washer → skadis peg board → bracket → nut.
The model was printed in PETG with 25% infill for strength but also to not take a large amount of time to print. I also tested the same print profile with PLA and it works just fine, however a brim is needed to prevent the corners from lifting.
**********************UPDATE***************************
I have updated the models to include an additional hole in the bracket to allow for it to be mounted in an offset fashion between the left and right upright rails of the Bror shelves. Indicated by the crude diagram below. I will update the images attached to the file when I have the opportunity.
I I
I I
0 0 ←
I I
I I
0 ← 0