HOLD MY BEER

started as meme, ended as carrier for up to 4 beers.

As a classic all-inclusive vacationer, it was always annoying to get more than 2 drinks because I only have 2 hands... But now I have the foldable holder to carry 4 drinks comfortably with one hand. After use, simply fold it up and put it in your trouser pocket or rucksack, etc.. Practical handle to carry the drinks safely from A to B. Also practical for festivals, opening is designed for standard plastic cups.

Printed are:
1x Handle
1x Threaded Rod
1x Upper plate with threaded screw connection in the plate
3x Lower plates with larger holes

Assembly:

1. Print all parts (lol)
2. Screw the threaded rod into the upper plate and secure with a little superglue
3. Slide the three other plates onto the threaded rod
4. Secure with wing nut
5. Clip the handle into the notch
6. Happy carry!

If you want more drink slots, the threaded rod can either be extended so that more plates from hmb_2-4_v2 can be slid on. The same applies to fewer slots, of course ;)

I printed the parts in PETG because they are probably primarily needed in warmer temperatures and in case you forget that it is still in the sun. PLA should also be strong enough, but then always make sure that it is not placed in the sun!

BTW: I only had 3 glases so thats why there are only 3 glases on the photo ;)