Print at 100% infill with a layer height of 0.04mm with a base layer of 0.24mm

The Model is 50x50mm in size
You may print at higher layer heights below the Min Depth of 1.4mm
The Max Depth is 2.4mm and the Actual Depth is 2.4mm

Filaments Used:
PLA PolyLite Natural Transmission Distance: 21
PLA BambuLab Basic Jade White Transmission Distance: 5
PLA+ Sunlu Grey Transmission Distance: 2
PLA+ Sunlu Red Transmission Distance: 6
PLA+ Sunlu Black Transmission Distance: 0.6
PLA+ Sunlu Sunny Orange Transmission Distance: 8
PLA+ Esun Space Blue Transmission Distance: 3.5
PLA+ eSUN PERPUL Transmission Distance: 5
PLA+ Esun Pink Transmission Distance: 5
PLA Hatchbox White Transmission Distance: 10
PLA+ Sunlu Yellow Transmission Distance: 10
This print uses 11 unique filaments

Swap Instructions:
Start with Natural
At layer #21 (1.04mm) swap to Jade White
At layer #37 (1.68mm) swap to Grey
At layer #41 (1.84mm) swap to Red
At layer #44 (1.96mm) swap to Black
At layer #46 (2.04mm) swap to Sunny Orange
At layer #47 (2.08mm) swap to Natural
At layer #48 (2.12mm) swap to Space Blue
At layer #49 (2.16mm) swap to PERPUL
At layer #50 (2.2mm) swap to Pink
At layer #51 (2.24mm) swap to White
At layer #52 (2.28mm) swap to Yellow
At layer #53 (2.32mm) swap to Natural

This slider is set higher than the mesh depth. It is not affecting your final mesh. Consider removing it.

Border Only Colors from here until the end.
At layer #55 (2.4mm) swap to Black for the rest.