thanks for the feedback! if you have suggestions on the support settings let me know

I hope this doesn't come off as downplaying your design. I tend to like models that don't require supports to begin with, my initial thought was to make the angle much steeper one near the edge of the blade or redesign it such that there is no angle. My issue was the edges of that part warping, I might be able to get better results if I just flipped that part upside down and had supports on the flatter side, not sure if that will work with the tiny tabs that hold the blade in though.

@cxy7722 I didn't have any issues with the piece warping. make sure your filament is dry. that part for me came out fantastic a few times. try using PC. I didn't have the overhang issue with that material