Solder Fume Extractor
Copyright Claim
Solder Fume Extractor
Boost
7
24
4
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.7 h
2 plates
Boost
7
24
4
0
4
1
Released
Description
This uses a 80mm Fan and 130mm filter. The fan is bolted straight into the model with M4 bolts. Both half of the print are glued together. The part that holds the filter will not come out nice without support but will be functional.
Comment & Rating (4)
All
Do you have plans for the rest of the set somewhere, as in controller and connectors to the fan?
The designer has replied
0
Reply
Hi @Lukasss I used some generic one of amazon. The one used in the build is this one: https://www.amazon.de/dp/B08JPS6DDP
The connector to the power brick was included with it (https://www.amazon.de/dp/B0C6M3FL31)
Hope that helps.
0
Reply
Replying to @kilianfritz
Definitely worth including these two items into the description (well now it's in the comments, so it helps). I was looking for something like this few weeks ago and went with 3rdparty (entire) set (120mm fan +controller/power unit). Thank you for providing these (and the model as well).
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
© 2024 MakerWorld