Sorry, in what way did it not fit? Maybe I can tweak it for you if you can give me some details? I used mine on a painted Skadis board, what kind of board are you using?

When you say it was too small, do you mean the eVacuum was a bit loose? It was a little loose with mine (0.5mm) but I decided that was better as it meant no chance of scratching the pump. I made the bottom part a tighter fit though which should grip it. Maybe you have some callipers? Let me know what exactly does not fit and by approximately how much and I can upload another model with a bit more/less tolerance if that's required. I'm keen to sort this out for you.

The problem is the rubber lip at the bottom of the eVacuum. If I remove this beforehand, the device fits into the holder very well. I'm afraid that the rubber lip will eventually break if I keep pulling it off. The width with the rubber lip at the bottom is 34mm for me.

Thank you! Looks so organized. I cram way too much on my walls ;-)

Yeah don't you hate that system. I did not want to give 3 stars to a print profile I had failed to print, but then later managed, but it did not register the print. I wanted to get rid of the rate button, so I loaded the profile and then added a negative modifier to the part so that only a tiny bit was visible, printed that and then it let me rate more than 3 stars. I guess you could also add a small cube and disable the original model. Glad the 3rd attempt worked. If you have the time to try the above and modify the rating it would be much appreciated. Have fun.