A simple can holder to hold spray bottles, tubes and cans of standard dimensions. Should fit most 100 ml bottles with a diameter of <46mm. Designed to fit snugly into most IKEA type cupboards, kitchen cabinets and the like - specifically in this case the IKEA PAX series of cupboards to make use of the existing peg holes.

Holes are spaced 32mm apart and the pegs are 4.7 mm
Platform is 46mm in diameter.

Based on the “Flaschenhalter” by Andon3d, but adjusted dimensions and design to fit a larger range of cans and bottles.

Recommend printing standing up with standard supports for the pegs to prevent them breaking along layer lines.

0.2 or 0.24 draft settings should be more than sufficient for these parts unless aesthetics are of particular concern.