Print Profile(1)
0.2mm layer, 4 walls, 15% infill
Designer
3.8 h
1 plate
Boost
9
5
4
1
9
1
Released
Description
This is a work in progress for a simple trellis system. Note, there is an issue with the STL as the top surface prints a bit wonky.
Comment & Rating (4)
All
Boosted
thanks for this! printing a test now.
Any chance you can add a second model that would slide over the 2x2, and connect the cross bars? thinking this could allow for a floating roof trellis.
The designer has replied
0
Reply
Yup! That was my original plan. Work has been crazy so I haven't had a chance to make/test it yet. I'll ping you when I do.
0
Reply
Added a couple more options. These should also be stronger, but haven't had a chance to print yet.
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
Bed Adhesion Issue
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld