[Skadis] Super Slim Hook V1 by ctrlaltrock

ctrlaltrock

Tools>Organizers

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

10 min

1 plate

3.8(6)

Open in Bambu Studio

Boost

Released

Description

Update: V2 is now available here - https://makerworld.com/en/models/503847

Most hooks for the SKÅDIS board are too wide for my application. Designed a super slim hook for the IKEA SKÅDIS Pegboard - perfect for items with small holes or tolerances. The width of the hook is only 2.3mm and I used them for items with small tolerences, including my cutter (5.5mm hole). Space between the hook is approximately 11mm. Ideas on how the hooks can be used are welcomed - do share them in the comments! Printed at standard 0.20mm layer height on my Bambu Lab A1M using generic PLA+ with auto (normal) support.

Note: As hook is slimmer than the support for the board side, it creates a floating cantilever, so please print with support.

Comment & Rating (9)

@peaceweapon

Print Profile

0.2mm layer, 2 walls, 15% infill

design is good, but support could be included in the file to print directly from handy app

The designer has replied

@ctrlaltrock

Thanks for the feedback and glad you found the design useful. The print profile is now updated with auto support. There is also an alternative slim hook design which might interest you: https://makerworld.com/en/models/503847

@NotThatCat

Print Profile

0.2mm layer, 2 walls, 15% infill

the default has this bending rather than sitting flush. it is very small and works well enough, but it's easy to pop off by mistake

The designer has replied

@ctrlaltrock

Thanks for your feedback. Have made several improvements based on the feedback provided. Do give V2 a shot here https://makerworld.com/en/models/503847

@Atanos

Print Profile

0.2mm layer, 2 walls, 15% infill

Great

@loudmime

Print Profile

0.2mm layer, 2 walls, 15% infill

Support Issue:most definitely needs supports

The designer has replied

@ctrlaltrock

Thank you for the feedback. As the hook is slimmer than the support for the board side, it creates a floating cantilever. I have included a note in the description to print with support. Great if you could share with the community if it works for you after the reprint :)