[Skadis] Super Slim Hook (11mmx2.3mm)
Copyright Claim
[Skadis] Super Slim Hook (11mmx2.3mm)
Boost
20
45
6
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
10 min
1 plate
Boost
20
45
6
1
17
14
Released
Description
Most hooks for the SKÅDIS board are too wide for my application. Designed a super slim hook for the IKEA SKÅDIS Pegboard - perfect for items with small holes or tolerances. The width of the hook is only 2.3mm and I used them for items with small tolerences, including my cutter (5.5mm hole). Space between the hook is approximately 11mm. Ideas on how the hooks can be used are welcomed - do share them in the comments! Printed at standard 0.20mm layer height on my Bambu Lab A1M using generic PLA+ with auto (normal) support.
Note: As hook is slimmer than the support for the board side, it creates a floating cantilever, so please print with support.
Comment & Rating (6)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
the default has this bending rather than sitting flush. it is very small and works well enough, but it's easy to pop off by mistake
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Support Issue:most definitely needs supports
The designer has replied
0
Reply
Thank you for the feedback. As the hook is slimmer than the support for the board side, it creates a floating cantilever. I have included a note in the description to print with support. Great if you could share with the community if it works for you after the reprint :)
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
© 2024 MakerWorld