The SYC Mouse - Show Your Colors is a simple mouse with a unique ability.
The Buttons print separately in up to 6 parts, they can be printed in any color, giving you the ability to Show Your Colors.
Prints in 1.5 hours with ZERO supports.
Examples:
IMPORTANT:
When Coloring your mouse buttons, pay attention to the object names. The buttons are printed upside down to be flat on the bed
Instructions:
Before Starting - Gather your parts from the kit and print file.
1 - Insert the Sensor Lens (Pay Attention to Orientation), Switch, and Slot in Battery Terminals
2 - Place the Mouse PCB in the Base by lining up the pegs, ensure that the switch on the underside is in the same position as the switch on the pcb. Plug in the battery connector
3 - Screw the Arm into place with one of the included screws from the Mouse Kit and ensure it is holding the PCB down firmly, Install the battery.
4 - Pay Attention to the orientation of the Middle Button specifically, it has a notch on it to ensure it allows the mouse wheel to spin freely.
5 - Press the buttons into their corresponding slots, M1 and M2 are identical and can be installed in any orientation, M3 is not. (TIP: Applying pressure from the inside with the cover flipped will ensure the button mechanisms aren't damaged)
If using the split buttons for a 6 color combination, Glue is definitely recommended
6 - Ensuring that the cables are inside, Place the cover over the base firmly. It should snap in place.
7 - Install the 4 included screws on the underside. If the Base of the Mouse and Your table are both the same color, Do not install the feet included with the Mouse Kit as the gap will interfere with the Mouse's Optical Sensor
8 - Your Mouse is complete! Depending on your Filament, Glue may not be necessary, though it is recommended
If using the split buttons for a 6 color combination, Glue is definitely recommended
All of my projects are 100% Free. However if you'd like to support me, feel free to buy me a coffee