Print at 100% infill with a layer height of 0.08mm with a base layer of 0.24mm

The Model is 150x195mm in size (Scale on on X and Y only to fit the bed, scaling on Z will mess with the colors)
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Red Transmission Distance: 4
PLA PolyLite Orange Transmission Distance: 7.5
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA BambuLab Basic Jade White Transmission Distance: 5
PLA Sunlu Transparent Transmission Distance: 50

This print uses 6 unique filaments

Swap Instructions:
Start with Black
At layer #11 (0.96mm) swap to Red
At layer #14 (1.2mm) swap to Orange
At layer #15 (1.28mm) swap to Yellow
At layer #18 (1.52mm) swap to Jade White
At layer #26 (2.16mm) swap to Transparent for the rest.

I printed this with a single AMS by assigning the 5th and 6th colors to the 1st and 2nd slots in the AMS then changing the filaments once it got to the 3rd color. Once the 3rd color starts you can pull out the 1st and 2nd and insert the 5th and 6th until the light comes on in the AMS feeder. The AMS will not automatically feed these filaments in until the come up in the sequence of printing. The Tranparent doesn't really show up to well, it looked good in Hueforge so I added it.

Enjoy!!!