SOAP/SPONGE TRAY
Copyright Claim
SOAP/SPONGE TRAY
Boost
41
80
10
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
2.8 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Boost
41
80
10
2
54
39
Released
Description
Say no more to a messy kitchen sink.
The inside of this tray is sloped and there is a drain in one of the corners so all excess water from the sponge can be removed.
In order to clean it, just remove the top piece and give it a good shower.
Comment & Rating (10)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
I measured the pads I normally use and needed to scale up the X & Y a little to match the insert size and turned out perfect first print. Thanks!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great file and great output thanks
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Related Models
© 2024 MakerWorld