P1S/X1C HEPA Filter for Chamber Exhaust
Copyright Claim
P1S/X1C HEPA Filter for Chamber Exhaust
Boost
39
95
6
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.5 h
1 plate
Boost
39
95
6
4
35
22
Released
Description
Replaceable HEPA Filter for Bambu Lab P1S and X1C Chamber Exhaust Fan
Mounts using the existing holes on the back of the printer. These may need to be tapped, but I used one of the currently existing screws adjacent to the fan to tap the holes.
You will need a total of 2 M3x6mm or similar length screws to mount the housing.
The filters I chose to use are located here (https://a.co/d/5rvBblT)
The seem well made and include a rubber gasket to help make a proper seal. They are also cost effective.
Comment & Rating (6)
All
Boosted
Much easier than the other I was using. Filters fit perfectly and printed well in ABS. Enjoy the boost.
The designer has replied
1
Reply
thank you much!
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Thank you for the print.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld