Print Profile(3)

All

P1P

P1S

X1 Carbon

X1E

0.2mm layer, 4 walls, 0% infill

Designer

58 min

1 plate

4.3(3)

0.2mm layer, 6 walls, 100% infill

Designer

1.5 h

1 plate

5.0(1)

0.2mm layer, 6 walls, 100% infill

Designer

1.3 h

1 plate

Boost

Released

Description

Summary

Version_2 Uploaded! The body is in one piece.

A gripper to hold your broom, mop, etc. It will hold from 19mm to 32mm (3/4" to 1-1/4")

I used PLA and TPE

Use a soft TPU or TPE. I tried with a harder TPU although it gripped it didn't automatically pop out when removing the broom.

Use 4 x M4x20 or #6x3/4" screws

Print Settings

Printer:

Mingda Rock 3

                                            Rafts:                      
No

Supports:

                                            Resolution:                      
0.3

Infill:

                Filament:                                     Overture Matte PLA, Spider Maker Matte TPE PLA, TPE                                    Black

Comment & Rating (6)

@billsbdb3

Print Profile

0.2mm layer, 6 walls, 100% infill

perfect!

@billsbdb3

Print Profile

0.2mm layer, 4 walls, 0% infill

printed fine! you’re right though. this is a little too tough. it does not pop back out. I’m using sainsmart 95a black

@NotForEveryone

Print Profile

0.2mm layer, 4 walls, 0% infill

Strength Issue:The issue with this is one corner near where the straight part connects is always torn. Every single time. I have printed at least 6 copies of this now and each one is ripped in the same spot. I believe the model needs to be updated on those corners to give it more strength.

@NotForEveryone

I updated this part of the model and made that hard edge a filet so it was less prone to having issues there. Seemed to make a difference for me. This could just be that I am printing it in 83A soft TPE.

@NotForEveryone

Replying to @NotForEveryone :

Okay so here you go it was 100% the seam and you can see it in the photo here. Top model is my fixed model, bottom is the original model. That single corner on the inside that is white is where every single one broke on me because of the seam. My fix causes no seam to be there by added a filet to thicken it a bit.

(Edited)