Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 200x200mm in size. You can adjust the X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.2mm
Filaments Used:
PLA PolyLite Black Transmission Distance: 0.3
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA PolyLite Grey Transmission Distance: 1
PLA PolyLite White Transmission Distance: 5
This print uses 4 unique filaments. Substitute as needed.
Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Blue Gray
At layer #14 (1.2mm) swap to Grey
At layer #19 (1.6mm) swap to White for the rest.