Meta Quest 3 Stand
Remixed by
Copyright Claim
Meta Quest 3 Stand
Remixed by
Boost
37
86
49
Print Profile(4)
0.2mm layer, 2 walls, 15% infill
Designer
5 h
1 plate
0.2mm layer, 4 walls, 20% infill
Designer
1.7 h
1 plate
0.2mm layer, 4 walls, 20% infill
Designer
2.1 h
1 plate
Modified top plate - 0.2mm layer, 3 walls, 15% infill
1.2 h
1 plate
Open in Bambu Studio
Boost
37
86
49
1
400
356
Released
Description
Meta Quest 3 stand for the headset and the controllers
The last piece is if you are using an elite strap or other 3d part strap
Comment & Rating (49)
All
The hole of the top plate is not angled so it was impossible to fit the top to the base.
With the top plate added, i cannot put the controllers in the holders without lifting the top plate first.. Was there wrong top included in the printprofiles? (file number two)
(Edited)
2
Reply
I've got the same issue. the top doesn't fit because the bit you slide it on to isn't angled. also the strap holders just flops about with no support. I did figure out though that the controllers go backwards and fit ok.
(Edited)0
Reply
Replying to @muzzy00_uk
Yes i was surprised since several gave the model full points. Maybe the model was changed sometime and wrong topplate was included. Print the top plate i created and attached in the printprofile and it will work better
(Edited)1
Reply
Print Profile
Modified top plate - 0.2mm layer, 3 walls, 15% infill
encaja bien
1
Reply
love it came out perfect
1
Reply
Print Profile
0.2mm layer, 4 walls, 20% infill
terminado. va perfecto
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
está bastante bien. aunque no me fijé y me hizo soportes en el 3. se me quedaron demasiados pegados. nada grave. cumplirá su función. gracias por el trabajo
(Edited)
0
Reply
Print Profile
Modified top plate - 0.2mm layer, 3 walls, 15% infill
Best print.
0
Reply
Print Profile
0.2mm layer, 4 walls, 20% infill
best q3 stand
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
live it and makes a perfect stand
0
Reply
Print Profile
0.2mm layer, 4 walls, 20% infill
printed great hold the q3 with das perfect
0
Reply
Print Profile
Modified top plate - 0.2mm layer, 3 walls, 15% infill
Zero issues printing. Very stable and works great. Highly recommend it. Thank you for sharing the model
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld