This clip was designed following the original BMW part but fits MANY if not all other cars since seatbelt width is standard.

Recommend printing in ASA, PETG or other filament tolerant of heat and resistant to creep (deformation under load).  PLA not recommended.

This clip holds the seatbelt buckle at a comfortable height near the shoulder, making it easier to grab to put on.  Also prevents the buckle from falling to the floor when removed.

The original part is injection molded and can stretch (so it doesn't stay in place anymore) and the clips holding the 2 halves together can break (which is what happened to mine).

This model matches the original part dimensions, but was redesigned for 3D printing.

NOTE: The tabs inside the clip that hold the seatbelt should be on opposite sides - routing the seatbelt in an “S” shaped path through the clip.  They should not align with each other or the clip will not close properly.

Print in any color to add a little flair to your interior, or print in black for the original look.

Fits these cars (and MANY more):