Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size. You can adjust the X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.2mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.3
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Pink Transmission Distance: 8
PLA BambuLab Basic Yellow Transmission Distance: 6
This print uses 4 unique filaments. Substitute as needed.

Swap Instructions:
Start with Black
At layer #6 (0.56mm) swap to Blue Gray
At layer #10 (0.88mm) swap to Pink
At layer #22 (1.84mm) swap to Yellow for the rest.