Packout 3 drawer divider bin by Cap’s Builds

Cap’s Builds

Tools>Organizers

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 3 walls, 15% infill

Designer

2.5 h

1 plate

Open in Bambu Studio

Boost

Released

Description

This is a removable bin for the Milwaukee Packout 3-drawer system. This bin is for the front right spot. Each divider has different cutouts so each bin is unique. Prints without support.

Comment & Rating (5)

@Kevinbasstech

Thank you for creating this, love the way these fit in the drawers so perfectly, really incredible! Question, when I printed mine out and put it in the drawer, the feature on the side, (I think it's where the drawer slide attaches to the drawer) You have an indent there, however on my drawer the feature in the drawer is about 3/4 inch taller than the feature you created, is there a way to edit that feature or am I doing something wrong or maybe I have newer drawers? Because of this the bin doesn't sit down all the way in the drawer.. Thank you

The designer has replied

@Agentlab

with the same question in this point, thinking there must ccontain one same groove

@cap.builds

Are you printing them for the 3 Drawer Packout? This one i modeled for is about 2-3 years old now. I did just get a new 2 drawer a couple of months back but haven't had time to model anything up for it, and have just been keeping tools loose in them.

@wood.brothers

do you do these for the 4 draws

The designer has replied

@cap.builds

I don't own any 4 drawers yet, I have a 2 drawer I plan to make one for soon. if the base of the bin fits in the bottom of the 4 drawer you could stop the print early to get right wall height without too many problems. I don't know if I'll be acquiring any 4 drawers soon.

No more