Fully 3d printed slide shoes, inspired by adilettes

• printed with TPU (I used Bambu Labs TPU 95A HF, but I suggest using a softer filament)

Important notes:

• It is for EU shoe size number 43 (male), but you can scale them to your size (use uniform scaling)

• If the shoe is too big to fit to the printers height, use the “WithSupport”-Version, rotate in Y-Axis (green) and use the cut tool in Bambu Studio to create a new flat surface parallel to the print bed
  • I uploaded an .stl file without cut on the bottom for better scaling

• There are two ways to print this:

1. Use a textured PEI bed and print it standing up without support (It works very well, especially with printers where the bed is not moved so much, such as P1S, P1P X1,…)
2. Or use another not so sticky bed and print it standing up with support (recommended for A1 or similar printers)

Check out my other models, for example the fully printed crocs shoes: https://makerworld.com/en/models/425034#profileId-328514

Have fun with it and leave a like or subscribe if you like it!

If there are any suggestions for improvement, feel free to write a comment.