Parametric Device Stand by Jonan Seeley

Jonan Seeley

Tools>Organizers

In Contest

OpenSCAD Master Challenge

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 3 walls, 20% infill

Designer

8 h

3 plates

4.7(7)

Boost

179

390

283

Released

Description

Parametric Device Stand

Simple stand for small to large devices of any thickness. Includes optional hexagonal cutout pattern for aesthetics/filament savings.

Note that due to limitations with editing vectors in the Customizer view in both OpenSCAD and MakerWorld, the number of devices is limited to 10. The code is somewhat rough but should be easily editable to add more devices if you require.

Key Features:

Device Thickness: Input the thickness of your devices to ensure a snug fit
Stand Width: Adjust the width of the stand to fit your desired dimensions
Divider Height: Customize the height of the dividers to separate your devices
Fillet Radii: Tune the fillet radii to control the curvature of the stand's edges
Hex Pattern: Enable or disable the hex pattern and adjust its details to suit your preferences

Instructions:

Measure the thicknesses of your devices
Input the measurements into the parameter list
Adjust the stand's other parameters to meet your desired specifications
Download and print your customized stand!

Comment & Rating (16)

@user_2239444227

Boosted

i can't generate a stand for just a single device. is that by design or am i doing something wrong? if i disable all but the first device the generated model looks like this.

The designer has replied

@JonanSeeley

Whooops, definitely not intended, should be fixed now. Thanks for pointing this out!!

@user_2239444227

Boosted

Replying to @JonanSeeley :

thanks a lot for the quick response. it works now as expected. thanks again!

@Coolman3005

Print Profile

0.2mm layer, 3 walls, 20% infill

Ist sehr stabil Könnte nur etwas weniger filament verbrauchen dann wäre es perfekt.

The designer has replied

@JonanSeeley

Perhaps not helpful now that you've already printed, but by lowering some of the general stand parameters (stand width, divider thickness, divider height, and others), the stand will be smaller and lower the filament usage. You can further adjust parameters such as the hex pattern gap and offset to lower filament usage even further, although eventually you will sacrifice some strength in the stand. Perhaps the default values lean too far towards strength instead of cost savings. Thank you for the feedback!

@user_2239444227

Boosted

love the idea. saves so much space on my desk. thank you!

(Edited)