Bambu X Finalmouse wireless gaming mouse by luca811

luca811

Hobby & DIY>Electronics

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

1.4 h

1 plate

4.8(4)

Boost

Released

Description

Finalmouse inspired shell for the Bambulab wireless mouse kit!

This version uses AAA battery and weights only 52g.

Instructions: shell piece has a snap system to put the PCB in place and you only will need 4 of the 6 screws that comes in with the kit. It is recommended to heat up the screw with a lighter while putting them in to make them going easily all the way into the hole.

IMPORTANT: mouse feet are needed, without them the PCB doesn't get stable signal and the mouse is not usable.

Some update might come while testing the model, cheers

Luca

Comment & Rating (8)

@M.Holicky

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Nice print, with cover for the battery and switch button would be perfect.

The designer has replied

@luca811

switch button coming soon! already modeled, just a print to check it works and I’ll upload the files

@M.Holicky

Boosted

Replying to @luca811 :

Superb!

@Hemanse

Printed fine, did it in petg as thats what i had on hand. The buttom part where the sensor is located was thin, so some came off while peeling from the plate. I will probably print something more fun to use the Bambu mouse kit on tho, the sensor is not good for anything other than browsing a little :)