This cookie cutter is divided by 4 parts: The Handle, the thread, the shape and the stamp. It's quite ergonomic cause It has a handle. Remind that you can unscrew It to save. After use It, employ the stamp to remove the cookie dough in the most difficult places. Then you can wash It with soap and water. Now, ENJOY YOUR ANGRY BIRDS COOKIES!

Note: you have to stick (with hot silicone), the thread file to the stamp one.

3D parameters:

You can print It with PLA.

Note: make you sure that the filament you are using is able to use for food.

In the handle and the thread you should use 0.16 mm because It has a M6 screw.

0.16 mm quality is so good but you can print the rest with 0.20mm.

Only support needed in the handle.

Is recommendable to use raft on the handle.