Hello Makerworld Community!

Introduction :

This is an model of a airplane yoke. I made it into a simplified version of the real model in an airplane but still have the same functions such as the up and down movement and also the rotational movement. which can move with a wide range of movement.

When you print this model there

should be a certain list of the 3D printed parts which is :

-1 Base (Connect with the stick)

-1 Stick (Connect With the base)

-1 Pin (Connect the base and stick)

-1 Rotating Base (Connecting the stick and the yoke)

-2 Nuts for the screw (Locking the screw between the rotating base with the stick and the yoke)

-1 Phone holder part (For the yoke phone holder)

-1 Yoke (for holding the phone and as a yoke itself)

Tools you will use to assemble

-None (it can be assembled easily.)

Steps To Assemble the Hexagonal Platform (See STL to see part names):

1. First, Take the base and the stick, then put the pin in between the hole of the base and the stick

2. Then put the other phone holder and put the rotational base on top of it to lock it in place.

3. After, insert the rotational base between the yoke screw and the stick.

4. then, rotate the nuts after you insert the screw of the yoke until it is locked

5. Next, rotate the nuts after you insert the screw of the rotational base into the stick until there is just enough friction.

6. After, that put your phone in the middle of the yoke and you are good to go.

7. Congrats, You've Done it!