OneBlade Shaver Travel Case
Copyright Claim
OneBlade Shaver Travel Case
Boost
47
123
10
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.5 h
1 plate
Boost
47
123
10
6
57
45
Released
Description
Just a quick travel case i made for OneBlade electric shaver. It should be a little tight so the shaver is properly protected.
Comment & Rating (10)
All
It's a very tight fit, and and the lid on my PLA print split the first time I opened it...
The designer has replied
1
Reply
you have to wiggle it the first time you open it. After 3-4x, it will become less tight and easier to take off/ put on.
1
Reply
Boosted
great model but a comparment for extra blades in the bottom would be great.
The designer has replied
1
Reply
thank you for the boost!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
A useful travel favor case to have prints very easy also.
The designer has replied
0
Reply
thanks so much! When you close it, its abit tight so make sure to wiggle it out carefully to take the lid of. Do this a few times and it will become easier to take it off
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Fits perfectly, prints nicely!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld