This is the surprised deadpool model from printables. I did the painting on the model prior to printing it out. I uploaded it here as I was unable to find this version on makerworld. 

I used Bambu PLA-Matte Red, MatterHackers Black, and MatterHackers White to print this headphone holder. 

.16 layer height

10% gyroid infill

Supports ARE USED\

*To ensure color bleed is minimal, filament flushing was set to 1.20

I like the bottoms of my prints smooth, so i use a high-temp smooth plate. I do run my PLA at 60c without issues as long as my machine is calibrated properly.

With this print pushing 42+ hours, I highly suggest performing a filament and flow calibration and ensuring that the you bed is leveled to minimize your prints chance at failing.