Pokemon Card:

• Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm.

Arcanine 3D model:

• Print at 15% infill with 3 wall loops with a layer height of 0.08mm with a base layer of 0.16mm.

All these are set within the print profile that I provided. I am open to feedback on the model as this is the first one I've made that includes a 3D model extruding from the Pokemon card. I've had some post-processing work to smooth out the supports around Arcanine.

This was all printed using 1 AMS while swapping out different spools as they completed. You must assign the 3 extra colors to an existing AMS slot and then switch the color out once it completes. Or you can set a pause instead, but you will need to make those modifications.

• Black Filament swap to Orange
• Green swap to Yellow
• Blue swap to White
   

Credits to TheCraftyMaker for the frame: https://than.gs/m/999108

Credits to etd_figurine for the Arcanine 3D model https://makerworld.com/en/models/484241#profileId-396576

Filaments Used:

• PLA SunLu Black Transmission Distance: 0.3
• PLA BambuLab Basic Green Transmission Distance: 2
• PLA BambuLab Basic Cyan Transmission Distance: 2
• PLA Overture Red Transmission Distance: 4.8
• PLA Sunlu Orange Transmission Distance: 5
• PLA Overture Red Transmission Distance: 4.8
• PLA BambuLab Basic Yellow Transmission Distance: 6
• PLA Kingroon White Transmission Distance: 6

Swap Instructions:

• Start with Black
• At layer #13 (1.12mm) swap to Green
• At layer #14 (1.2mm) swap to Cyan
• At layer #16 (1.36mm) swap to Red
• At layer #18 (1.52mm) swap to Orange
• At layer #20 (1.68mm) swap to Red
• At layer #21 (1.76mm) swap to Yellow
• At layer #25 (2.08mm) swap to White for the rest.