This is a simple model for displaying a CD on pegboard, use with 6mm hole diameter and 25mm hole spacing pegboard.

I would recommend printing it at a layer height of less than 0.12mm, if the walls are too rough it could cause it to scratch on the CD case.

The way I have placed the model makes the most sense and I don't recommend changing it. If you print it in PLA, the model is strong enough vertically to support the weight of the CD.
Do not lay the model flat, as this will cause the hooks to be weak and break.

这是一个用于在洞洞板上展示CD的模型，适用于6mm孔径，25mm孔距的洞洞板。

我会建议使用低于0.12mm的层高打印它，如果墙壁过于粗糙，可能在CD外壳上产生划痕。

我对模型的摆放方式已经是最合理的，不建议更改它。如果您使用PLA打印它，模型在垂直方向的强度足以支撑CD的重量。
请不要将模型平放，这将导致钩子强度不足并断裂。