Doesn't the trigger hurt your finger every time when you pull the trigger of your beloved firefly? This is a small mod for thickening the trigger, so that it won't hurt your finger anymore.

Print guide

Print vertically on the bed, apply brim if necessary. Support is basically not required, but use it when you actually need. Any layer height should be fine. Material is not limited, but flex material might offer a better touch.

Install guide

Choose either one from two methods for fastening:

A. (recommended) Use a flat head M2 screw, you need to drill a crew hole on the corresponding trigger side. In this way, you can change the part whenever you want.

B. Glue it on. This is a permanent solution, but the easiest way to install. It wouldn't affect dissemble of the blaster.