This is a handy lure box that you can attatch to your belt or pants! It has brackets for dividers that you can print as many as you need.  It's optimal for going out to the river, not too big and in an easy spot to reach. 

Print settings:

I used PETG but i think ABS and PLA will work too.

15% infill is fine

0.2mm layer height

Lid, bottom and bracket need support. I used manual support on the lid and bottom, and then automatic support on the bracket. I left the inside part of the hinge without support, even though the program wants to fill it, and it turned out just fine.