Hand Vise

MAKE SURE TO PRINT THE SCREW AT 0.14 LAYER HEIGHT OR ELSE IT DOES NOT THREAD PROPERLY

I saw something similar in an Adam savage video a while back and thought to myself “that would be useful” so I made it. It is great for holding small things while sanding so that you do not have to strain your hand.

Assembly

1. Print everything out(you don't need the TPU jaw covers but it is much stronger with them)
2. Insert the rod into the smaller hole of the jaw without threads and super glue it in place
3. Insert the screw into the top hole in the jaw without the threads
4. Thread the little nut onto the screw and super glue that in place(make sure that you do not accidentally glue the screw to the jaws of the vise)
   1. I recommend doing that buy placing a bit of glue infront of it and then threading it over the glue you placed
5. Screw on the other jaw
6. Insert the jaws into the handle
7. You can superglue it in but I found the friction fit to be good enough