Welcome to the next Droid from Star Wars: Knights of the Old Republic!
I present to you: MK-1 Fully Articulating, poseable and game/lore accurate model (Mark-1) Defense Droid.

I've redesigned here, a machine that had no right to be moveable in the game, lots of parts that didn't make sense, now just WORK!

This is currently built for the A1 MINI, and can print in six plates. You CAN condense and print in fewer, but this allows for one print every ~2 hours, and you won't waste a print.

Design Notes:
**** Print the PINS Plate with 50-100% infill**** to add strength to those pins. If not, they simply snap off when pressure is added. You can also angle them, or lay them flat, however you run the risk of losing accuracy and they not fitting.

If you find your shafts aren't sticking properly, or are too hard to press in, just scale and reprint the PINS. Depending on the tolerance of your printer, the holes fluctuate quite a bit.

HOWEVER! This model CAN scale up and down, to whatever size you want!
The ONLY pin that you may need to swap, is the Arm Elbow/Neck PIN X3, for the exact sized one found in the downloads. ALL other parts are exact fits, and will be perfect scaled!