Blood Moon
Blood Moon
Print Profile(1)
Description
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 200x200mm in size. You can adjust the X and Y but the Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.2mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.3
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Grey Transmission Distance: 1
PLA BambuLab Basic White Transmission Distance: 5
PLA BambuLab Basic Orange Transmission Distance: 5
PLA BambuLab Basic Red Transmission Distance: 4
PLA BambuLab Basic Yellow Transmission Distance: 6
This print uses 7 unique filaments. Substitute as needed.
Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Blue Gray
At layer #11 (0.96mm) swap to Grey
At layer #15 (1.28mm) swap to White
At layer #19 (1.6mm) swap to Orange
At layer #23 (1.92mm) swap to Red
At layer #25 (2.08mm) swap to Yellow for the rest.
Comment & Rating (0)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
