Filament Container Mount for Multiboard
Copyright Claim
Filament Container Mount for Multiboard
Boost
169
343
11
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
1.4 h
1 plate
Boost
169
343
11
6
161
30
Released
Description
Filament Container Mount for Multiboard:
The filament containers are cereal storage which can be found on Amazon here: https://www.amazon.com/dp/B08HQ7133Y?psc=1&ref=ppx_yo2ov_dt_b_product_details
The multiboard should be mounted off surface
The mount attaches to the multiboard with 3x 20mm Small Thread, Flat Head, T-bolt
Additionally you can use a 15mm Wall Support Peg on the front of the multiboard to add stability and prevent tilting of the container (with optional velcro dot for extra security); see pictures attached.
Comment & Rating (11)
All
Boosted
YOU ARE MY HERO!!!! These containers are EVERYWHERE in my printing room. I am always tripping over them! I have a BOX of multiboard stacks, 7X7 ready to put up and use! I have a small 4' by 5' section covered of my wall now, but im about to change that due to these! THANK YOU so much.
12
Reply
co to za urządzenie po prawej stronie? Osuszacz, oczyszczacz czy klimatyzator powietrza?
what is that device on the right? Dehumidifier, purifier or air conditioner?
The designer has replied
0
Reply
Air purifier. My printer is in a basement.
0
Reply
air freshener or dehumidifier?
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
etwas zu kurz, sollte etwas länger sein damit die Behälter nicht kippen. Kann man aber skalieren.
The designer has replied
0
Reply
Da ich kein Deutsch spreche, erfolgt dies über Google Translate, aber dafür ist der 15-mm-Wandstützstift an der Vorderseite des Multiboards gedacht. Um die Stabilität zu erhöhen und ein Kippen des Behälters zu verhindern. Ich empfehle auch den Klettverschluss, um ihn am Haken zu befestigen und für zusätzliche Sicherheit zu sorgen. Durch die Skalierung kann sich die Größe der Befestigungslöcher ändern und die Funktion beeinträchtigen.
0
Reply
Could you link the attachment required for the multiboard please?
The designer has replied
0
Reply
Multiboard is free and can be found here. https://www.multiboard.io/
The part name is exactly as written in the description.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld