Need a beefy pc to slice!
This one is a BIG one.. +10h printing.
250mm in diameter.
(if you want to scale it, scale only the X and Y dimensions, Z must be 2.01mm to maintain the right colors).
The round lightbox and the lid (logo) are a very tight fit.. you have to use great force with your thumbs
to snap it in place. You then also have a slightly bulging effect.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA BambuLab White Transmission Distance: 9.6
PLA BambuLab Basic Yellow Transmission Distance: 4
PLA BambuLab Magenta Transmission Distance: 4
PLA BambuLab Basic Black Transmission Distance: 0.8
Swap Instructions:
Start with White
At layer #12 (1.04mm) swap to Yellow
At layer #15 (1.28mm) swap to Magenta
At layer #22 (1.84mm) swap to Black for the rest.
Happy Printing,
and Thundercats HOOO!
All the designs i upload, i have to print first, and that's a lot of filament 😬 And filament isn't free..
So, if you like my work you could
buy me a coffee if you like. 😉
https://www.buymeacoffee.com/a.vdh_83
Or a donation via Paypal is also much appreciated.
https://www.paypal.com/donate/?hosted_button_id=3KZUPFUG4KLUL