I recently started printing high temperature filaments like ASA, and I noticed that my upgraded P1P - P1S was struggling to keep the fumes and the temperature required inside the chamber.
So I searched for ways to fix this, and after doing the same for the rear gap, I did this joint to fill the gap at the front of the printer too, between the glass plate and the front cover.
This joint is designed to be “invisible” from the outside of the printer, it also centers the glass plate.
Just use the provided 3MF for TPU 95A HF, just be careful to print them one after the other to avoid TPU stringing.
Just remove the glass plate carefully, and place the two joints in the spots shown in the photos.