Simple Bambu build plate holder. I wanted something that held 4 plates and stood on it's own without a flange on the side or added feet. Bambu logo on both front and rear. Model without logo is also provided.
very well model, is doing its job. but one modification I would like.to add is to add some place where can put some weight to be sure it will be heavier and stand on table a bit better.
Nice plate holder. I had a couple of plates leaning on the side of my printer, and over time, the vibration caused them to scratch the finish. This solves that problem perfectly. Printed in Bambu PLA with a 0.8mm nozzle in just over two hours.