Logo Design: Edmonton Oilers Logo

Details of the design:

This has been done in LightBox Format to save filament and weight.
The box is about 15mm deep.
The Face consists of the logo and sides.
The Face (0.6mm) has a thin layer called FaceBack (0.6mm), usually White, to diffuse light.
The back consists of the Backplate (2mm) and Lip (3mm) to hold the sides. The Sides to Backplate should be a friction fit but due to humidity or your printer you may need some glue. I use E6000 if needed and printed all in Bambu Lab PLA Basic.
In Bambu Studio, click from Global to Objects to modify colors to fit your AMS locations.
 

This was done on a Bambu Lab A1 with 0.4mm Nozzle, 0.2mm Layer Height, Textured PEI Plate, Face DOWN for consistent texture, 5x5x3mm Prime Tower, reduced Flush Volume to 0.7, Wall Generator is Arachne, 15% Gyroid Sparse Infill.

REMEMBER to change the PRINTER and NOZZLE to match what you are using.