Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size. X and Y can be adjusted but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.3mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.3
PLA BambuLab Basic Gray Transmission Distance: 2.5
PLA BambuLab Basic White Transmission Distance: 6
This print uses 3 unique filaments, Substitute as needed.

Swap Instructions:
Start with Black
At layer #10 (0.88mm) swap to Gray
At layer #18 (1.52mm) swap to White for the rest.